Plastic Injection Molding

V-shaped Sealing Ring

V-shaped sealing ring The V-shaped sealing ring has a V-shaped cross-section and is also a lip sealing ring. The V-shaped sealing ring device consists of three components: a support ring, a...

EPDM Seat Seal

EPDM seat seal Performance characteristics of EPDM seat seal: EPDM rubber gasket has good heat resistance, ozone resistance and aging resistance but poor oil resistance. In addition, EPDM...

PTFE Oring

PTFE Oring Polytetrafluoroethylene sealing rings (PTFE) are closed rings with an annular cross-section, the same as synthetic rubber O-rings; PTFE Orings are not produced by mold processing,...

Nylon Scraper

Nylon scraper The scraping machine is a device that scrapes a certain thickness on the surface of the food to form a sheet of food. Usually, the driving mechanism drives the nylon scraper or...

PPS Plastic Washer

PPS plastic washer PPS is a special crystalline engineering plastic that has good heat resistance and excellent chemical resistance, mechanical properties, electrical properties and dimensional...

ABS Injection Molding Parts

ABS injection molding parts Plastic shrinkage and plastic knowledge during injection mold processing Conventional varieties and classifications of plastics In daily life, most of the plastics...

Rubber Sealing Ring

Rubber sealing ring The working principle of the rubber sealing ring is to achieve the sealing effect through its elastic deformation and friction. In the design and manufacture of mechanical...

Diaphragm

Diaphragm Diaphragm material composition Diaphragm material is the basic material for our diaphragms. They contain a media-resistant composite consisting of at least two components: an...

Nylon Bushing

Nylon bushing Nylon bushing features: 1. It has self-lubricating properties and excellent wear resistance. Among engineering plastics, it is a type of material with a high PV value; 2. Even...

UHMW-PE Product

Ultra high molecular weight (UHMW) polyethylene (PE) combines outstanding abrasion resistance and low coefficient of friction with outstanding impact strength.

UHMW-PE Guide Rail

UHMWPE has a maximum continuous operating temperature of plus 90°C and a short term operating temperature of plus 120°C. Its a very tough material, with the highest impact strength of any...

UHMW-PE Gear

UHMW (ultra high molecular weight polyethylene) is an extremely tough plastic with high abrasion and wear resistance.