PPO Injection Molding

PPO Flange

PPO parts is make by injection molding, and accessories of different shapes can be completed according to the design mold.

PPO Part For Water Meter

Good dimensional stability and electrical properties.
High heat distortion temperature above 100°C (up to 195 °C).
Modified PPO blends are soluble in moderately polar solvents

PPO Injection Part

Shtraction rate: 0.8% -1.5%
Pre-drying: dry at 110℃ for 2h.
Measurement trip: 0.5-3.5D
Back pressure: 3-10 MPa

PPO Impeller

PPO engineering plastic spare parts  
PPO injection molded impeller 
PPO pump impeller

PPO Housing

PPO box 
PPO hood 
PPO transformer shielded units 
PPO insulation pillars